Removal Of Oil Pump And Internal Components; Removing Governor Feed Screen; Removing Inner Lever And Actuating Rod; Removing Manual Shaft Retainer - Pontiac Grand Prix Service Manual

TURBO HYDRA-MATIC TRANSMISSION M-38 7G-13
Fig. 7G.18 Removing Governor Feed Screen
shaft from the case and remove the parking pawl (Fig.
76-22).
20. From valve body case face, remove intermediate
servo piston, its aluminum oil seal ring, apply pin,
washer, spring seat and spring (Fig. 76-23).
REMOVAL OF OIL PUMP AND INTERNAL
COMPONENTS
1. Move transmission to vertical position (oil pump
face up), scribe a mark on pump body and transmis-
sion case face for aid in alignment on reinstallation
and remove eight (8) pump attaching bolts with
washer-type seals (Fig. 76-24).
SE RETAINER
SC-REWDRIVER
UPARKlNG PAWL
Fig. 7G-20 Removing Inner Lever and Actuating Rod
2. Install two (2) Slide Hammers J 6125-1 and
Adapters J 6125-2 into threaded bolt holes in pump
body (at approximately 4 and 11 o'clock) and remove
pump assembly from case.
3. Remove pump-to-case gasket and tools from pump.
Discard gasket.
4. On V-8 models, remove intermediate clutch cushion
spring, three (3) intermediate clutch faced plates and
three (3) steel separator plates; on 6 cylinder models,
remove cushion spring, two (2) faced plates and two
(2) separator plates (Fig. 76-25),
5. Remove intermediate clutch pressure plate.
Fig. 7G-19 Removing Manual Shaft Retainer
Fig. 7G-21 Removing Manual Shaft Oil Seal