Installing Center Support And Gear Unit; Installing Center Support Bolt; Installing Center Support To Case Snap; Ring - Pontiac Grand Prix Service Manual

Table of Contents

PONTIAC SERVICE MANUAL

Fig. 7E-154 lnstalling Center Support and Gear Unit

Both sides of this snap ring are flat.

14. Check rear end play as follows:

a. Install J 21904 with 3/8" adapter into an extension

housing attaching bolt hole (Fig. 7E-158).

b. Mount Dial Indicator J 8001 on rod and index with

end of output shaft.

c. Move output shaft in and out to read end play. End

play should be from .003"-.019". The selective washer

controlling this end play is a steel washer having 3 lugs

and is located between thrust washer and rear face of

transmission case.

If a different washer thickness is reauired to brine end

C E N T E R SUPPORT

LOCATING TOOL

Fig. 7E-156 Installing Center Support Bolt

play within specifications, it can be selected fro-m the

following chart:

. 3 Tabs O.D.

15. Install front band with anchor hole placed over

band anchor pin and apply lug facing servo hole (Fig.

16. Install manual linkage as follows:

a. If necessary, install a new manual shaft seal into

Fig. 7E-155 lnstalling CEnter Support to Case Snap

Fig. 7E-157 lnstalling Intermediate Backing Plate

and Clutch Plates

Show Quick Links

Table of Contents