Cooler Pipe - Pontiac And Grand Prix; Installation Of Power Steering Pump For V-8 - Pontiac Grand Prix Service Manual

9-52 1969
PONTIAC SERVICE MANUAL
ALTERNATOR 6 PULLEY ASSY.
Fig. 9-99 Installation of Power Steering Pump for V-8
Engines
(counterclockwise as viewed from front) until air 7. Remove radiator with shroud from car,
bubbles cease to appear.
8. Remove screws attaching two cooler pipe brackets to
bottom of radiator and remove cooler pipe.
COOLER PIPE
-
PONTIAC AND GRAND PRlX
INSTALL
REMOVE
1. Drain radiator.
1. Install cooler pipe by reversing above steps.
2. Disconnect transmission cooler lines from radiator if
2. Tighten fan blade bolts to 20 lb. ft. torque.
car is equipped with automatic transmission.
3. Fill radiator with coolant.
3. Cut each clamp attaching each return hose to cooler
pipe (Fig. 9-80 and 9-82). Discard clamps.
4. Check and correct transmission fluid level.
4. D i s c o ~ e c t upper and lower radiator hoses.
5. Check and correct power steering fluid level.
5. Remove fan blade.
6. Check for fluid leaks at a 1 hose and pipe
6. Remove screws attaching shroud to radiator support. co~ections that were disconnected.
GENERAL SPECIFICATIONS
MANUAL STEERING
Type: Saginaw Recirculating Ball Nut
Steering Gear Ratio
Pontiac, Tempest, Grand Prix, Firebird
(except Firebird V-8 with A/C). .24:
1
Firebird V-8 with A/C.
.........
.28:1
tubricant capacity.
................
. l l Fluid Ounces
Worm Beaiinn Preload..
.............
7 lb. in.
Overcenter or-pitman Shaft Adjustment
(in excess of Worm Bearing
Preload).
...........
:
...........
4 to 10 Ib. in.
(Total worm bearing adjustment, pitman shaft
adjustment and drag not to exceed 16 lb. in.)