Rear End Play Checking Procedure; Removing Parking Bracket; Removing Parking Pawl Return Spring - Pontiac Grand Prix Service Manual

7E-16
1969 PONTIAC SERVICE MANUAL
Fig.
7E-33
Removing Manual Shaft Retaining Pin
from Case
f. Remove parking pawl return spring (Fig. 7E-36).
NOPE: The following steps are to be completed only
if
one or more of the parts involved require replacement:
g. Remove parking pawl shaft retaining spring (Fig.
7E-37).
h. Remove parking pawl shaft cup plug by inserting a
screwdriver between the parking pawl shaft and the
transmission case rib (Fig. 7E-38).
i. Remove parking pawl shaft and parking pawl (Fig.
7E-39).
Fig.
7E-35
Removing Parking Bracket
8. Remove front band (Fig. 7E-40).
9. Remove sun gear shaft (Fig. 7E-41).
REAR END PLAY CHECKING PROCEDURE
6
10. Check end play as follows:
a. Install J 21904 into an extension housing attaching
bolt hole.
b. Mount Dial Indicator J 8001 on rod and index with
end of output shaft (Fig. 7E-42).
c. Move output shaft in and out to read end play. End
play should be from .003" to .019". Selective washer
controlling this end play is steel washer having 3 lugs.
It is located between thrust washer and rear face of
transmission case.
Fig.
7E-34
Removing Detent Lever and Jam Nut
from Manual Shaft
Fig.
7E-36
Removing Parking Pawl Return Spring