Idle Stop Solenoid - Pontiac Grand Prix Service Manual

ENGINE FUEL 6B-5
IDLE STOP SOLENOID (FIG. 6B-9)
ADJUSTMENT
The idle stop solenoid, used on six-cylinder and Ram
Air engines, is adjusted as follows:
Adjust plunger in or out to obtain specified solenoid
energized idle speed (see idle specification chart,
section 6D). Observe operation of solenoid by discon-
necting lead. With engine running at specified hot idle
speed, the plunger should drop back allowing the
carburetor idle .mew to contact the idle cam. In this
position the engine speed should drop to the specified
lower "solenoid inactive" speed.
Fig. 68-9 Idle Stop Solenoid
-
(6 Cyl. Shown)
Fig. 68-10 Accelerator Linkage
-
Tempest and Grand
Prix
AFTER INSTALLING SWITCH ASM. DEPRESS
,
PLUNGER FULLY IN DIRECTION O F ARROW "E"
AS S H O W N T O INSURE PROPER ,SETTING.
SPREAD ENDS
AFTER INSTALLATION
L 4 C A R B . EXTENSION
VlEW A
BRACKET
[ALL ENGINES)
CARB. EXTENSION
SECTIONAL VlEW SHOWING
INSTALLATION OF CABLE
TO BRACKET ALL ENGINES
-IDLER LEVER
ENGINE BRACKET
6 CYL. 1 BBL. CARB. ENGINE 6 CYL. 4 BBL. CARB. ENGINE
7