Pontiac Grand Prix Service Manual page 607

7G-44 1969
PONTIAC SERVICE MANUAL
Fig. 7G-113 Installing Low and Reverse-To-Sun Gear
Thrust Washer
NOTE: Washer has three (3) wide external tangs.
23. Install direct clutch drum-to-forward clutch drum
needle roller bearing and install forward clutch
assembly into direct clutch assembly.
24. Holding by input shaft, install clutch assemblies
onto input ring gear (Fig. 76-26).
CAUTION: Make certain that fonvard clutch faced
plates are positioned over input ring gear and that tangs
on direct clutch housing are installed into slots on sun
gear drive shell. Make certain that clutch plates are
indexed with their respective parts before going further.
Fig. 7G-114 Installing Ring Gear-To-Output Carrier
Thrust Washer
Fig. 7G-115 lnstalling Intermediate Clutch Pressure
Plate
25. Install intermediate overrun brake band with
anchor lug and apply lug positioned properly.
4
26. Install intermediate clutch pressure plate (Fig. 7 6
115), lubricate with transmission fluid and:
a. On V-8 models, install three (3) intermediate clutch
faced plates and three (3) steel separator plates,
starting with a faced plate and alternating steel
separator plates (Fig. 76-25).
b. On 6 cylinder models, install two (2) faced and two
(2) separator plates, starting with a faced plate.
NOTE: Notch in steel separator plates should be placed
in case notch adjacent to selector lever inner bracket
(4:OO dclock position).
27. Install intermediate clutch cushion spring.
28. Install new pump-to-case gasket on face of case
and install new pump body-to-case O-ring seal (square
cut) on pump cover.
29. Aligning marks made on disassembly, install oil
pump to case.
30. Install all but one (at 4 o'clock position) pump
attaching bolts and tighten alternately to 20 lb. ft.
torque.
NOTE: Use new washer-type seals on pump bolts.
IMPORTANT: If the input shaft can not be rotated as
the pump is being pulled into place or the pump can not
be pulled down properly, the direct and forward clutch
housings have not been installed properly to index the
faced plates with their respective parts. This condition