Installation Of Strainer And Intake Pipe; Installation Of Modulator Valve And Vacuum Modulator; Installing Rear Accumulator Spring; Installing Rear Servo Cover And Gasket - Pontiac Grand Prix Service Manual

TURBO HYDRA-MATIC-M-40
73-57
ACCUMUCATOR SPR
Fig. 7E-173 Installing Rear Accumulator Spring
2. Install governor pipes into valve body.
3. Install two guide pins (control valve assembly
attaching screws with heads removed ) (Fig. 7E-177).
4. Install control valve and governor pipes to transmis-
sion.
NOTE: Be sure manual valve is properly indexed with
pin on manual detenr lever and governor pipes are
proper& installed in case.
5. Install control valve assembly attaching bolts and
detent roller and spring assembly (Fig. 7E-178).
6. Tighten detent solenoid and control valve attaching
bolts. Torque valve body bolts to 8 lb. ft. and solenoid
bolts to 8 Ib. ft.
Fig. 7E-175 Installing Rear Servo Cover and Gasket
INSTALLATION OF STRAINER AND INTAKE PIPE
1. Install case to intake pipe O-ring seal on intake pipe
and assemble new strainer to intake pipe (Fig. 7E-16).
2. Install strainer and intake pipe assembly, attaching
strainer to control valve assembly with the retainer
bolt (Fig. 7E-15).
NOTE: Ajier any major repair, the strainer must be
replaced and oil cooler and cooler lines must be flushed.
3. Install new bottom pan gasket and bottom pan with
attaching screws. Torque to 12 lb. ft.
INSTALLATION OF MODULATOR VALVE AND
VACUUM MODULATOR
1. Install modulator valve into case, stem end out.
Fig. 7E-174 Installing Rear Servo
Fig. 7E-176 Installing Control Valve to Spacer Gasket