Horn Relay Buzzer Alarm; Side Marker Lamps; Pontiac Instrument Panel Installation; Brake Warning Light Switch - Pontiac Grand Prix Service Manual

CHASSIS ELECTRICAL SERVICE
12-25
C L U S T E R MOU NnNG S T U D S
- -
. . . .
-.
-
. .
'NSTRUMENT PANEL C L U S T E R
WARNING LAMPS
lN$TRUHENT PANEL PLATE
LOWER INSTRUMENT PANEL COVER
Fig.
12-26
Pontiac Instrument Panel Installation
2. Remove horn wire. SIDE MARKER LAMPS
3. Remove retaining screw.
4. Remove horn.
5. To replace reverse removal procedure.
HORN RELAY ANDBUZZER ALARM
ALL-REMOVE AND REPLACE
1. Remove wire conneciors.
2. Remove relay retaining screw.
3. Remove relay.
4. To replace, reverse removal procedure.
BRAKE WARNING LIGHT SWITCH
ALL-REMOVE AND REPLACE
Front side marker lamps on grand Prix models consist
of a reflecting surface integral with the park lamp. All
other models are equipped with a plastic lamp
retained to the front fender by a steel retainer. Bulb
and socket then twist into lamp. The marker lamp is of
single filament type and has a single wire leading to it
from the front end harness. The rear marker lamp,
located in the quarter panel is also fed by a single wire
contained in the rear harness.
INSTRUMENT PANEL CLUSTER
Removal of these units can be accomplished by using
the following installation diagrams: Fig. 12-26, 12-27,
12-24, and by referring to the below procedures.
PONTIAC-REMOVE AND REPLACE
ALL-REMOVE AND REPLACE
1. Disconnect battery.
It is necessary to remove brake line distributor to 2. Remove lower instrument panel cover.
replace brake warning light switch. Instructions for
removal of the switch can be found in Section 5.
3. Remove radio.