Firebird Shift Controls - Pontiac Grand Prix Service Manual

FOUR-SPEED MUNCIE MANUAL TRANSMISSION
7D-3
SHIFT CONTROL LEVER
@
LUBRICATE WITH
CHASSIS LUBRICANT
A
3 0 LB. FT.
SHIFT LEVER WITH
GAGE PIN IN PLACE
60 LB. FT. (NEUTRAL POSITION)
2.25"R
A
20 LB. FT.
--f
4
+
CONSOLE MOLDING
GAGE PI
A
25 LB. FT.
VIEW C
SHIFT LEVER SEAL
CALLOUT FOR MEMBER TO BE TORQUED.
TORQUE SYMBOL IS ADJACENT TO
CIRCLE
Z
REVERSE
SHIFTER LEVER
SHIFTER LEVER SHIFTER LEVER
TROL ROD
CIRCLE Y
CONTROL ROD
C Q N ~ ~ L .
ROD
(3rd & 4th)
CIRCLE X
(lit
a
2nd)
( 1 s t - 2 N D )
VIEW A
Fig. 7D-2 Firebird shift Controls
4. Install retainer bolt and lockwasher and tighten to 4 3. Use punch or other suitable tool to loosen oil seal
Ib. ft. torque.
from extension, remove and discard (Fig. 7D-4).
5. Connect speedometer cable to speedometer driven
4. Wash counterbore with cleaning solvent and inspect
gear and sleeve assembly.
for damage.
TRANSMISSION EXTENSION OIL SEAL
REMOVE
AND REPLACE
5. Inspect propeller shaft yoke for nicks, burrs or
scratches which would cut new seal or cause seal to
leak or damage bushing.
6. Coat new seal with sealing compound and press
Remove
lock plates (or lochashe*)
Straight inlo bore
of
case extension with
J
5 154-A (Fig.
and U-bolts from rear axle drive pinion flange.
7D-5).
NOTE: If tie wire has been removed, use rubber band to CAUTION: Do not excessively force the seal against the
hold bearings onto journals to prevent loss of needle
seat in the extension.
bearings when rear joint is disconnected.
7. Install propeller shaft assembly by reversing steps 1
2. Slide propeller shaft assembly rearward to disen- and 2 above. Coat outside diameter of yoke with gear
gage yoke from splines on transmission mainshaft. lubricant before assembly.