Installing Reaction Carrier Into Case; Installing Low And Reverse Clutch ~ G C K - Pontiac Grand Prix Service Manual

TURBO HYDRA-MATIC TRANSMISSION
M-38 7G-43
Fig. 7G-111 Installing Reaction Carrier into Case
retaining ring and remove tools (Fig. 76-36).
NOTE: If clearance for installing snap ring is not
available, low and reverse clutch piston is probably not
alignedproperly in case.
8. If,output ring gear was separated from output shaft,
inst ' 1 1 ring gear to output shaft, retaining with a new
snaa ring (Fig. 76-39.
I
9. Install reaction carrier-to-output ring gear thrust
washer into output ring gear face (Fig. 7G-110).
NOTE: Washer has three (3) narrow external tangs.
10. Install output ring gear-to-case needle bearing onto
output shaft and install output shaft assembly into case
(Fig. 76-34).
NOTE: Lip of needle gearing faces rear of case.
11. Install reaction carrier assembly onto output shaft
assembly (Fig. 7G-111).
12. Lubricate plates with transmission fluid and:
a. On V-8 models, install five (5) low and reverse
clutch faced plates and five (5) steel separator plates
into reaction camer assembly, starting with a steel
separator plate and alternating with faced plates (Fig.
7G-112).
b. On 6 cylinder models, 'install four (4) faced and four
(4) separator plates into reaction carrier, starting with
a steel separator plate.
NOTE: Notch in steel separator plates should be placed
in
bottom notch (5:30 dclock position) of case.
Fig. 7G-112 Installing Low and Reverse Clutch ~ g c k
(V-8
Model)
13. Install low and reverse clutch support retainer
spring (Fig. 76-32).
14. Install low and reverse roller clutch and support
assembly into case, puslfing firmly until support
assembly is seated past the top of low and reverse
clutch support retainer spring (Fig. 7G-31).
IMPORTANT: Make certain splines on inner race of
roller clutch align with splines on reaction carrier.
15. Install low and reverse roller clutch support-to-case
retaining ring (Fig. 7G-30).
16. Install low and reverse roller clutch inner race-to
sun gear drive shell thrust washer into roller clutch
inner race (Fig. 7G- 1 13).
NOTE: Washer four (4) wide internal tangs.
17. Install sun gear drive shell assembly into low and
reverse roller clutch and support assembly (Fig.
76-29).
18. Install output camer assembly into drive shell (Fig.
76-28).
19. Install new output carrier-to-output shaft snap ring.
C A UTION: Do not overstress snap ring.
20. Install input ring gear-to-output carrier thrust
washer (Fig. 7G-114).
NOTE: Washer has four (4) internal tangs.
21. Install input ring gear (Fig. 76-27).
22. Install forward clutch housing-to-input ring gear
thrust washer into input ring gear face.