Inspection Of Reaction Carrier; Installing Intermediate Clutch Inner Seal; Installing Intermediate Clutch Piston; Assembly Of Center Support 7 ~ 1 4 - Pontiac Grand Prix Service Manual

7E-40
1969 PONTIAC SERVICE MANUAL
Fig. 7E-113 lnstalling lntermediate Clutch Inner Seal
ASSEMBLY OF CENTER SUPPORT
1. Install new inner and outer seals on piston with lip
of seal facing away from spring pocket (Fig. 7E-113
and 7E- 1 14).
2. Install Inner Seal Protector Tool J 21363 on center
support hub and install piston, indexing spring pockets
of piston into cored areas of center support (Fig. 7E
1 15).
3. Install three (3) release springs into counterbores of
piston. Space equally during assembly.
4. Place spring retainer and snap ring over springs.
5. Compress springs and install snap ring.
6. Install four (4) hook type oil rings.
Fig. 7E-115 Installing lntermediate Clutch Piston
7. Air check operation of intermediate clutch piston
.
(Fig. 7E- 1 16).
INSPECTION OF REACTION CARRIER;
ROLLER CLUTCH AND OUTPUT CARRIER
ASSEMBLY
1. Inspect band surface on reaction carrier for signs of
burning or scoring.
2. Inspect roller clutch outer race for scoring or wear.
3. Inspect thrust washer surfaces for signs of scoring or
wear.
4. Inspect bushing for damage. If bushing is damaged,
reaction carrier must be replaced.
5. Inspect reaction carrier pinions for damage, rough
bearings or excessive tilt.
Fig. 7E-114 Installing lntermediate Clutch Outer
I
Seal
Fig. 7E-116 Air Checking Intermediate Clutch Piston