Removal Of Control Valve Assembly - Pontiac Grand Prix Service Manual

TURBO HYDRA-MATIC-M-40 7E-11
Fig. 7E-12 Removing Governor Cover Attaching
Screws
6. Remove the strainer retainer bolt (Fig. 7E-15).
7. Remove the strainer and intake pipe assembly (Fig.
7E-16).
8. Remove intake pipe to case O-ring seal from intake
pipe or case and discard.
REMOVAL OF CONTROL VALVE ASSEMBLY,
SOLENOID CONNECTOR, GOVERNOR
PIPES AND DETENT SPRING ASSEMBLY
1. Remove control valve body attaching screws and
detent roller spring assembly (Fig. 7E- 17).
Fig. 7E-14 Removing Transmission Oil Pan
Attaching Screws
NOTE: Do not remove solenoid attaching screws.'
2. Disconnect solenoid lead from connector terminal.
3. Remove control valve body assembly and governor
pipes (Fig. 7E-18).
CA UTION: Do not drop mmual valve.
4. Remove governor pipes from control valve assem-
bly.
5. Remove control valve assembly to spacer gasket.
REMOVAL OF REAR SERVO, VALVE BODY SPACER,
GASKET AND FRONT SERVO
1. Remove rear servo cover attaching screws, servo
cover and gasket. Discard gasket (Fig. 7E-19).
2. Remove rear servo from case (Fig. 7E-20).
Fig. 7E-13 Removing Speedometer Driven Gear
Retainer Fig. 7E-15 Removing Strainer Bolt