Power Cylinder Only; Master Cylinder Only - Pontiac Grand Prix Service Manual

5D-10 1969 PONTIAC SERVICE MANUAL
4. Place gage J 22647 over piston rod in a position
which will allow gage to be slipped to the right or left
without contacting the studs. (Fig. 5D-16)
NOTE: GAGING IS TO BE PERFORMED WITH-
OUT VACUUM.
The center section of the gage has two levels. The
piston rod should always never contact the longer
section (lower level) of the gage. The piston rod should
never contact the shorter section (higher level) of the
gage. Move gage from side to side to check piston rod
height.
unit to dash attaching nuts. Torque nuts to 24 lb. ft.
2. Attach pushrod "eye" to pedal arm pin with retainer
clip.
3. Position master cylinder over attaching studs and
install two nuts. Torque nuts' to 25 lb. ft.
4. Install vacuum hose and vacuum check valve.
5. Check stop-light switch adjustment (see Section 5).
MASTER CYLINDER ONLY
-
INSTALL
,,hation beyond these two limits must be
1. Position master cylinder on power cylinder studs.
compensated for by obtaining the service adjustable
Secure master cylinder with two nuts; torque to 25 lb.
pushrod, and adjusting the self-locking screw to meet
ft.
gaging specifications.
2. Attach hydraulic fluid lines.
POWER CYLINDER ONLY
-
INSTALL
3. Fill master cylinder reservoirs and bleed brakes as
1. Mount power cylinder to dash. Install four power described in Section 5.
TORQUE SPECIFICATIONS
-
LB. FT.
Power Cylinder to Master Cylinder Attaching Nuts.
.
.25
Power Cylinder to Dash Attaching Nuts..
.
.
.
. . . . . .
.24