7G-30
1969
PONTIAC SERVICE
MANUAL
DIRECT CLUTCH D R U M
P I S T O N RETURN
S P R I N G SEAT
DIRECT CLUTCH
P I S T O N ASSEMBLY
R E T A I N I N G R I N G
FACED PLATE
DIRECTCLUTCH PRESSURE PLATE
Fig.
7G-71
Exploded View o f Direct Clutch Assembly
press, compress tbrward clutch piston return spring
IMPORTANT: Roller clutch assembly must be installed
seat and remove retaining ring.
with rollers up (toward front of transmission).
4. Remove tool, spring seat, twenty-one (21) piston
11. Install intermediate overrun clutch outer race,
return springs and forward clutch piston assembly
retainer and front retaining ring (Fig. 76-63).
(Fig. 76-77).
NOTE: When overrun roller clutch assembly is properly
installed, outer race will free wheel counterclockwise
only.
FORWARD CLUTCH ASSEMBLY
DISASSEMBLY
1. Place forward clutch assembly in hole in bench, with
input shaft down, and remove forward clutch drum-to
pressure plate retaining ring and forward clutch
pressure plate (Fig. 76-75).
2. On
V-8
models, remove five (5) faced plates, five (5)
steel separator plates and forward clutch housing
cushion spring; on 6 cylinder models, remove four (4)
faced and four (4) separator plates and cushion spring
(Fig. 76-76).
3. Using Clutch Spring Compressor
J 23327-1 in arbor
Fig.
7G-72
Removing Direct Clutch Drum Bushing
CAPE CHISEL