Ignition Lock Assembly; Lubrication; Manifold Heat Control Valve; Station Wagon Tailgate Hinge And Linkage - Pontiac Grand Prix Service Manual

0-8 1969 PONTIAC SERVICE MANUAL
IGNITION LOCK ASSEMBLY
-
INSTALL
1. With key inserted in lock part way, assemble wave
washer and special lock washer over lock as shown in
Fig. 0-13.
2. Align tang of washer over side bar of lock and insert
assembly into cylinder so that tang on washer enters
slot in cylinder.
NOTE: Be sure plastic lock in cylinder does not interfere
with assembly.
3. When lock is fully seated in cylinder, push key in all
the way and turn clockwise.
4. Assemble lock and cylinder assembly into steering
column. See Section 9.
LUBRICATION
ITEMS REQUIRING LUBRICATION OR
SERVICE AT 4 MONTHS OR 6,000 MILE
INTERVALS, WHICHEVER OCCURS FIRST
ENGINE OIL
Change As Outlined Below
RECOMMENDED SAE VISCOSITY NUMBERS-
20W1 low-30,
low-40,ZOW-40
I
10~-3bl
l o w ,
10~-'40
,5W-2015W-301
-2)0
'
d
' 2 b '4b
'
6' 0
8b I ~ o
Temperature Range Anticipated Before
Next Oil ChangelT
NOTE: SAE 5 W and
5
W-20 oils are not recommended
for sustained high speed driving. 'SAE 3 0 W oils
may
be
used at temperatures above W F .
NOTE: All engines are equipped with specially engi-
neered piston rings. These rings allow oil to flow freely
on the cylinder walls during the break-in period.
Therefore, oil consumption may be higher during the
break-in period than it will be afierward.
Oil which according to the label on the can is intended
for service MS and conforms to GM Standard 6041M
should be used.
OIL FILTER
Change at first oil change; every other oil change
thereafter.
MANIFOLD HEAT CONTROL VALVE
Observe for freedom of movement. Lubricate with
heat valve lubricant.
STATION WAGON TAILGATE HINGE AND LINKAGE
Engine oil every six months, more often if required.
CHASSIS LUBRICATION
Lubricate all normally greased suspension parts includ-
ing ball joints.
POWER STEERING SYSTEM AND PUMP RESERVOIR
Maintain lubricant level with GM power steering fluid,
part 1050017. If this lubricant is not available, use
DEXRON,
or equivalent, automatic transmission fluid.
STANDARD DIFFERENTIAL
Check for leaks, maintain lubricant level with SAE-80
oil where available or SAE-90 Multi-Purpose gear
lubricant meeting requirements of MIL-L-2105B.
Change lubricant only when necessary,to disassemble.
SAFE-T-TRACK DIFFERENTIAL
Check for leaks. Refill with part 1050081 lubricant
only. Change lubricant only when necessary to
disassemble.
MANUAL TRANSMISSION
Check for leaks. Maintain lubricant level with SAE-80
where available or SAE-90 Multi-Purpose gear lubri-
cant meeting requirements of MIL-L-2105B. Change
lubricant only when necessary to disassemble.
CLUTCH LINKAGE MANUAL TRANSMISSION
Check lash and adjust as required. Lubricate with
chassis grease at push rod to clutch fork joint and at
cross shaft.
COLUMN SHIFT LINKAGE, MANUAL TRANSMISSION
Engine oil' at all joints below steering column shift
levers. Chassis grease at cross shaft bearing points.
FLOOR SHIFT' LINKAGE, MANUAL TRANSMISSION
Engine oil at all joints under body (lubricate shifter
mechanism liberally).
BRAKE SYSTEM AND MASTER CYLINDER
Check system for adequate brake pedal reserve and for