Transaxle Side Case Cover; Drive Link Assembly (Chain) - Pontiac Fiero 1988 Service Manual

ON-VEHICLE SERVICE 7A1-15
7. Bolt securing TCC solenoid to auxiliary valve
body and solenoid. Remove TCC solenoid wir-
ing connector from case connector.
8. TCC wires from third gear pressure switch.
9. Bolt securing T.V. linkage and bracket assem-
bly to valve body and T.V. linkage.
10. Remaining bolts securing valve body to case
cover and valve body being careful not to loose
the six check balls. Do not remove the green
bolt.
11. Green bolt and separate auxiliary valve body
from valve body.
F*1 Install or Connect
1. Auxiliary valve body to valve body with green
bolt.
2. Check balls in valve body.
3. If necessary, use petroleum jelly to hold check
balls in.
4. For placement of check balls, refer to specific
transaxle Section 125C.
5. Valve body to case cover.
6. T.V. bracket and linkage.
7. TCC wires and wiring connectors.
8. TCC solenoid.
9. Valve body cover with a new gasket.
10. Left rear wheel and tire assembly.
11. Lower vehicle.
12. T.V. cable.
13. Air cleaner.
14. Negative battery cable.
1 7 1
Adjust
• T.V. cable. Refer to Figure 9.
• Fluid level. Refer to Section 7A.
TRANSAXLE SIDE CASE COVER
Tools Required:
J 28467-A
1. Negative battery cable.
2. Air cleaner.
3. T.V. cable at injection linkage.
4. T.V. cable from transaxle rod.
• Install J 28467-A. Raise engine enough to
take pressure from motor mounts.
CAUTION:
Bodily injury could result
with improper use of support fixture.
Engine support must be located in cen-
ter of cowl and fasteners must be
torqued before supporting engine. Fix-
ture is not intended to support entire
weight of engine and transaxle.
5. Transaxle engine mount bolts.
7. Left rear wheel and tire assembly.
8. Valve body.
9. Oil pump drive shaft.
10. Transaxle cooler pipes and plug to prevent
leakage.
11. External transaxle electrical connector.
12. Case attaching bolts and manual valve.
• Install two 12 X 1.95 X 14 bolts in dowel
pin holes and tighten to pull case cover
loose.
F+|
Install or Connect
1. Manual valve.
2. Case cover, 11 Nnn (98 lbs. in.).
3. Electrical connector.
4. Oil cooler lines.
5. Oil pump drive shaft.
6. Valve body.
7. Left rear wheel and tire assembly.
8. Lower vehicle.
9. Remove engine support fixture.
10. T.V. cable at injector linkage and transaxle.
11. Air cleaner.
12. Negative battery cable.
E3
Adjust
• T.V. cable.
DRIVE LINK ASSEMBLY
(CHAIN)
When disassembling any 125/125C inspect the
drive link assembly (chain) for wear.
1. Remove the case side cover to expose the drive
link (chain).
SCRIBE MARKS
IF DIMENSION EXCEEDS
1-1/16 INCH — REPLACE
DRIVE LINK
G20026-7A
Figure 11 C h e c k i n g Drive Link (Chain) W e a r