Shaft Reassembly - Pontiac Fiero 1988 Service Manual

5-SPEED ISUZU MANUAL TRANSAXLE 7B2A-9
Shaft Reassembly
Input Shaft
Before assembling, apply oil to the thrust sur-
faces on all gears and washers.
1. Install the needle bearing and 3rd gear, and
install the block ring next.
2. Match the inserts of the 3rd/4th sleeve and hub
assembly with the grooves of the blocker ring
and press the sleeve and hub assembly and col-
lar. Using J 33374 and a press (Figure 27).
Before installing, apply oil to the collar and hub
interiors. After installation, apply oil to the cir-
cumference of the collar. Check to ensure the
insert springs do not interfere with the hub after
installation.
3. Install the blocker ring and needle bearing, and
install the 4th gear and thrust washer next.
Install the thrust washer with the recessed area
facing 4th gear.
4. Install the front and rear bearings using J 33374
and a press (Figure 28 and 29). Before install-
ing, apply oil to the bearing interior and race
surface.
Output Shaft
Before assembling, apply oil to the thrust sur-
faces on all gears. Apply oil to all the bearing interiors
and race surfaces.
1. Install the thrust washer, thrust needle bearing,
1st gear and blocker ring.
2. Match the inserts of the sleeve and hub assem-
bly with the grooves of the blocker ring and
press the sleeve and hub assembly together with
the collar using J 8853-01, pilot J 33369 and a
press (Figure 30).
G 3 4 0 2 6 7 B 2 - A N
J33374
G34027-7B2-AN
Figure 28 Front Bearing Input Shaft
J33374
G 3 4 0 2 8 7 B 2 - A N
Figure 29 Rear Bearing Input Shaft
Figure 27 3rd/4th Sleeve/Hub and Collar
Figure 30 Collar Sleeve and Hub (1st)