3. T.v. Cable; Intermediate Servo And/Or; Governor; Accumulator Check Valve - Pontiac Fiero 1988 Service Manual

7A1-14 ON-VEHICLE SERVICE
|y| Inspect
• Shift linkage.
INTERMEDIATE SERVO AND/OR
ACCUMULATOR CHECK VALVE
F+l Remove or Disconnect
1. Raise vehicle
a n d s u i t a b l y
support,
s e e
Section OA.
2. Oil pan.
3. Oil strainer and "O" ring seal.
4. Reverse oil pipe brackets.
5. Intermediate servo cover and gasket.
6. Third accumulator valve and spring.
7. Intermediate servo assembly.
F ^ j Install or Connect
• Refer to exploded view in the Transaxle Unit
Repair Section.
1. Intermediate servo assembly.
2. Third accumulator valve and spring.
3. Servo cover with a new gasket.
4. Reverse oil pipe brackets.
5. Oil strainer with a new seal.
6. Oil pan. Refer to Section 7A.
7. Lower vehicle.
1 2 3 Adjust
• Fluid level. Refer to Section 7A.
GOVERNOR
F * |
Remove or Disconnect
1. Raise vehicle and suitably support, see
Section OA.
2. Governor cover and "O" ring.
3. Governor assembly.
F+l
Install or Connect
1. Governor assembly.
2. Governor cover and "O" ring.
3. Lower vehicle.
F I L L E R T U B E
Figure
10
F*l Remove or Disconnect
1. Fluid level indicator and nut or bolt retaining
tube mounting bracket.
2. Raise vehicle and suitably support, see
4. Lower vehicle.
5. Pull tube and seal out of vehicle from the top.
Install or Connect
1. Filler tube and seal.
2. Raise vehicle and suitably support, see
Section OA.
3. Locate filler and seal tube on transaxle.
4. Lower vehicle.
5. Filler tube mounting bracket.
6. Fluid level indicator.
V A L V E B O D Y C O V E R
F + l Remove or Disconnect
1. Raise vehicle and suitably support, see
Section OA.
2. Left rear wheel and tire assembly.
3. Valve body cover to transaxle bolts.
F + l Install or Connect
1. Valve body cover with a new gasket and bolts.
2. Left rear wheel and tire assembly.
3. Lower vehicle.
A U X I L I A R Y V A L V E B O D Y , V A L V E B O D Y
AND OIL PUMP ASSEMBLY
F+l Remove or Disconnect
1. Negative battery cable.
2. Air cleaner.
3. T.V. Cable.
4. Raise vehicle and suitably support.
5. Left rear wheel and tire assembly.
6. Valve body cover.
1. FLUID L E V E L 3. S E A L - I N S T A L L IN C A S E B E F O R E
INDICATOR INSERTING T U B E
2. T U B E 4. 9 N-m (80 L B S . IN.)
J10004-7A1-P
Figure 10 Filler Tube and Indicator