And Governor Pipes 7E-57; Installation Of Strainer And Intake Pipe - Pontiac tempest 1968 Service Manual

7E-58
1968 P O N T I A C SERVICE M A N U A L
Fig. 7E-163 Installing Rear Servo
3. Install two guide pins (control valve assembly
attaching screws with heads removed) (Fig. 7E-166).
4. Install control valve and governor pipes to
transmission.
NOTE: Be sure manual valve is properly indexed
with pin on manual detent lever and governor pipes
are properly installed in case.
5. Install control valve assembly attaching bolts
and manual detent and r o l l e r assembly (Fig. 7E-167).
6. Tighten detent solenoid and control valve at­
taching bolts. Torque valve body bolts to 8 l b . f t .
and solenoid bolts to 8 lb. ft.
INSTALLATION OF STRAINER AND INTAKE PIPE
1. Install case to intake pipe O-ring seal on Intake
pipe and assemble new strainer to Intake pipe (Fig.
7E-17).
REAR S E R V O C O V E R
\
REAR S E R V O G A S K E T
F i g . 7E-165 Installing Control V a l v e to Spacer Gasket
2. Install strainer and intake pipe assembly, at­
taching strainer to control valve assembly with the
retainer bolt (Fig. 7E-16).
NOTE: After any major repair, the strainer must
be replaced.
3. Install new bottom pan gasket and bottom pan
with attaching screws. Torque to 12 l b . ft.
INSTALLATION OF MODULATOR VALVE AND
VACUUM MODULATOR
1. Install modulator valve into case, stem end out
(Fig. 7E-168).
2. Install O-ring seal on vacuum modulator.
3. Install vacuum modulator into case.
F i g . 7 E - 1 6 4 Installing Rear Servo Cover and Gasket
F i g . 7E-1 66 Installing Control V a l v e Assembly and
Governor Pipes