Notes On The Stop/Cut Position Of Different Media - SATO SG112-ex Operator's Manual

5 Adjusting the Product
5.4.4

Notes on the Stop/Cut Position of Different Media

Cut Position when Using the Label in Cutter Mode
The regular cut position is between labels (only cut
on the liner).
When you cut the label, the glue adheres to the
blade of the cutter and the blade will decrease the
performance of the cutter. Adjust the cut position so
as not to cut the label.
Cut Position when Using the Media with Perforated Line in Cutter Mode
Adjust the cut position so as not to cut the media on the perforated line and on the area near side from
the perforated line (the area is shown in the figure below).
When the media is cut on the area not to be cut, it could cause a paper jam or damage.
• Media Roll
The area not to be cut is on the perforated line
and on the area within 1 mm (0.04") near side
from the perforated line.
• Fan-fold Media
The area not to be cut is on the perforated line
and on the area within 4 to 25 mm (0.16" to
0.98") near side from the perforated line.
150
SG112-ex Operator Manual
Cut Position
Cut Position
Cut prohibited zone
(1 mm, 0.04")
25 mm (0.98")
Area not to be cut
Label
Liner
Label
Perforated line
4 mm (0.16")
Perforated
line