Show Ethernet Cfm Errors - Cisco MWR 2941 Command Reference Manual

show ethernet cfm errors

show ethernet cfm errors
To display connectivity fault management (CFM) continuity check error conditions logged on a device
since it was last reset or since the log was last cleared, use the show ethernet cfm errors command in
privileged EXEC mode.
CFM IEEE 802.1ag Standard (CFM IEEE)
Syntax Description
domain
domain-name
configuration
domain-id
mac-address
dns
dns-name
null
service
ma-name
ma-num
vlan-id
vlan-id
vpn-id
vpn-id
Command Default In CFM IEEE, when no maintenance domain is specified, errors for all domains are displayed.
In CFM D1, when no maintenance domain or maintenance level is specified, errors for all domains and
all levels are displayed.
Command Modes
Privileged EXEC (#)
Command History Release
12.2(33)SRA
12.4(11)T
12.2(33)SXH
12.2(33)SXI2
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
492
show ethernet cfm errors [configuration | domain-id {mac address | domain-name | dns
dns-name | null} [service {ma-name | ma-num | vlan-id vlan-id | vpn-id vpn-id}]]
(Optional) Indicates that a maintenance domain is specified.
(Optional) String of a maximum of 154 characters.
(Optional) Displays the configuration error list information; for example,
port, VLAN, and error condition.
(Optional) Displays by domain ID.
(Optional) MAC address of the maintenance domain.
(Optional) Displays a domain name service (DNS).
(Optional) String of a maximum of 43 characters.
(Optional) Indicates there is not a domain name.
(Optional) Displays a maintenance association within the domain.
(Optional) String that identifies the maintenance association.
(Optional) Integer that identifies the maintenance association.
(Optional) Displays a VLAN.
(Optional) Integer from 1 to 4094 that identifies the VLAN.
(Optional) Displays a virtual private network (VPN).
(Optional) Integer from 1 to 32767 that identifies the VPN.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.4(11)T.
This command was integrated into Cisco IOS Release 12.2(33)SXH.
This command was integrated into Cisco IOS Release 12.2(33)SXI2.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01