Network-Clock Quality-Level - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

network-clock quality-level

To specify a quality level for a line or external timing device, use the network-clock quality-level
command in global configuration mode. To remove a quality-level configuration, use the no form of this
command.
Syntax Description
tx
rx
value
interface
interface-name The name of the interface connected to the clock input.
slot
card
port
controller
e1
BITS
slot
card
port
external
2m
10m
Command Default None
Command Modes
Global configuration mode
OL-23890-01
network-clock quality-level {tx | rx} value {interface interface-name slot/card/port | controller
[E1| BITS] slot/card/port | external [2m | 10m] }
no network-clock quality-level {tx | rx} value {interface interface-name slot/card/port |
controller [E1| BITS] slot/card/port | external [2m | 10m] }
Specifies a quality level for transmitted traffic.
Specifies a quality level for received traffic.
Defines the quality level. Valid values are:
• QL-PRC
• QL-SSU-A
• QL-SSU-B
QL-SEC
•
QL-DNU
•
Specifies the interface connected to the clock input.
The slot of Router/Switch where the clock source is present.
The bay in which card is inserted.
The port of the card.
Specifies the controller connected to the clock source.
Specifies the E1 controller.
Specifies the BITS controller.
The slot of Router/Switch where the clock source is present.
The bay in which card is inserted.
The port of the card.
Specifies an external interface.
Specifies the 2 MHz interface.
Specifies the 10 MHz interface.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
network-clock quality-level
271