Spanning-Tree Mst Hello-Time - Cisco MWR 2941 Command Reference Manual

spanning-tree mst hello-time

spanning-tree mst hello-time
To set the hello-time delay timer for all the instances on the router, use the spanning-tree mst hello-time
command in global configuration mode. To return to the default settings, use the no form of this
command.
Syntax Description seconds
Command Default 2 seconds
Command Modes Global configuration (config)
Command History Release
12.2(14)SX
12.2(17d)SXB
12.2(33)SRA
15.0(1)MR
Usage Guidelines
If you do not specify the hello-time value, the value is calculated from the network diameter.
Examples This example shows how to set the hello-time delay timer:
Router(config)# spanning-tree mst hello-time 3
Router(config)#
Related Commands Command
show spanning-tree mst
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
636
spanning-tree mst hello-time seconds
no spanning-tree mst hello-time
Number of seconds to set the hello-time delay timer for all the instances on the
Catalyst 6500 series switch; valid values are from 1 to 10 seconds.
Modification
Support for this command was introduced on the Supervisor Engine 720.
Support for this command on the Supervisor Engine 2 was extended to
Release 12.2(17d)SXB.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
This command was integrated into 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Description
Displays the information about the MST protocol.
OL-23890-01