Cns Config Retrieve - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

cns config retrieve

To enable the Cisco Networking Services (CNS) configuration agent and initiate a download of the
initial configuration, use the cns config retrieve command in privileged EXEC mode.
Syntax Description host-name
ip-address
encrypt
port-number
page
page
overwrite-startup
retry retries
interval seconds
syntax-check
no-persist
source
interface name
status url
event
inventory
OL-23890-01
cns config retrieve {host-name | ip-address} [encrypt] [port-number] [page page]
[overwrite-startup] [retry retries interval seconds] [syntax-check] [no-persist] [source
interface name] [status url] [event] [inventory]
Hostname of the configuration server.
IP address of the configuration server.
(Optional) Uses a Secure Sockets Layer (SSL) encrypted link to the event
gateway.
(Optional) Port number of the configuration service. The value is from 0 to
65535. The default is 80 with no encryption and 443 with encryption.
(Optional) Indicates that the configuration is located on a web page.
(Optional) Web page where the configuration is located. The default is
/cns/config.asp.
(Optional) Replaces the startup configuration file. Does not apply to the
running configuration file.
(Optional) Specifies the retry interval. The range is 0 to 100. The default is
0.
(Optional) Specifies the time in seconds, before the next attempt to request
the configuration of a device from a configuration server. The range is 1 to
3600.
(Optional) Turns on syntax checking.
(Optional) Suppresses the default automatic writing to NVRAM of the
configuration pulled as a result of issuing the cns config retrieve command.
If not present, issuing the cns config retrieve command causes the resultant
configuration to be automatically written to NVRAM.
(Optional) Specifies the source of CNS communications.
(Optional) Interface name of the source of the configuration.
(Optional) Sends the configuration the specified URL via HTTP, either
notifying successful completion of the configuration or warning that the
configuration contained errors.
(Optional) Sends an event to the CNS Event Bus stating successful
completion of the configuration, a warning that the configuration contained
errors, or a message noting that the configuration failed. If the CNS event
agent is not configured, the event will be saved until the CNS event agent
is enabled. If the event keyword is not specified, a log message is sent to
the console of the device after the configuration is complete.
(Optional) Sends an inventory of the line cards and modules in the router to
the CNS configuration engine as part of the HTTP request.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
cns config retrieve
71