Ethernet Oam Link-Monitor High-Threshold Action - Cisco MWR 2941 Command Reference Manual

ethernet oam link-monitor high-threshold action

ethernet oam link-monitor high-threshold action
To configure a specific action to occur when a high threshold for an error is exceeded on an Ethernet
operations, maintenance, and administration (OAM) interface, use the ethernet oam link-monitor
high-threshold action command in configuration template mode. To remove the high-threshold action,
use the no form of this command.
Syntax Description
error-disable-interface
failover
Command Default
A high-threshold action is not configured.
Command Modes Configuration template (config-template)
Command History Release
12.2(33)SRA
12.4(15)T
12.2(33)SXH
12.2(33)MRA
15.0(1)MR
Usage Guidelines
The failover action is applicable only to EtherChannel interfaces. It provides an automatic failover of
traffic from one port in an EtherChannel to another port in the same EtherChannel when one of the ports
in the channel exceeds the high threshold for an error within the specified interval. The port failover
occurs only if at least one operational port is in the EtherChannel. The failed port is put into an
error-disable state. If the failed port is the last port in the EtherChannel, the port will not be put into the
error-disable state and will continue to pass traffic regardless of the types of errors received.
Single, nonchanneling ports go into the error-disable state when the error high threshold is exceeded
within the specified interval.
Examples The following example shows how to configure an error-disable-interface action to occur when the high
threshold for an error is exceeded:
Router(config-template)# ethernet oam link-monitor high-threshold action
error-disable-interface
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
150
ethernet oam link-monitor high-threshold action {error-disable-interface | failover}
no ethernet oam link-monitor high-threshold action
Performs an error-disable function on the interface.
Performs a failover to another port in the same PortChannel.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.4(15)T.
This command was integrated into Cisco IOS Release 12.2(33)SXH.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support the failover keyword.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01