Mpls Ip (Interface Configuration) - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

mpls ip (interface configuration)

To enable Multiprotocol Label Switching (MPLS) forwarding of IPv4 packets along normally routed
paths for a particular interface, use the mpls ip command in interface configuration mode. To disable
this feature, use the no form of this command.
Syntax Description This command has no arguments or keywords.
Defaults
MPLS forwarding of IPv4 packets along normally routed paths for the interface is disabled.
Command Modes
Interface configuration
Command History Release
12.0(10)ST
12.0(14)ST
12.1(2)T
12.1(8a)E
12.2(2)T
12.2(4)T
12.2(8)T
12.0(21)ST
12.0(22)S
12.0(23)S
12.2(14)S
12.2(13)T
12.2(28)SB
12.2(33)SRA
12.2SX
12.4(20)MR
12.2(33)MRA
15.0(1)MR
OL-23890-01
mpls ip
no mpls ip
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.0(14)ST.
This command was integrated into Cisco IOS Release 12.1(2)T.
This command was integrated into Cisco IOS Release 12.1(8a)E.
This command was integrated into Cisco IOS Release 12.2(2)T.
This command was integrated into Cisco IOS Release 12.2(4)T.
This command was integrated into Cisco IOS Release 12.2(8)T.
This command was integrated into Cisco IOS Release 12.0(21)ST.
This command was integrated into Cisco IOS Release 12.0(22)S.
This command was integrated into Cisco IOS Release 12.0(23)S.
This command was integrated into Cisco IOS Release 12.2(14)S
This command was integrated into Cisco IOS Release 12.2(13)T.
This command was integrated into Cisco IOS Release 12.2(28)SB and
implemented on the Cisco 10000-PRE2 router.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
This command is supported in the Cisco IOS Release 12.2SX train. Support
in a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
This command was integrated into Cisco IOS Release 12.4(20)MR.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
mpls ip (interface configuration)
247