Network-Clock Hold-Off Global - Cisco MWR 2941 Command Reference Manual

network-clock hold-off global

network-clock hold-off global
To configure a general hold-off timer, use the network-clock hold-off global command in global
configuration mode. To disable a general hold-off timer, use the no form of this command.
Syntax Description
0
hold-off-value
Defaults 300 ms
Command Modes Configuration mode (config)
Command History Release
15.0(1)MR
Usage Guidelines
A network holdoff timer determines the amount of time that the router waits when a synchronous
Ethernet clock source fails before taking action. After the holdoff timer expires, the router announces
the failure and switches to another clock source or holdover mode.
Examples This example shows how to configure a global hold-off timer value:
Router(config)# network-clock hold-off 400 global
Router(config)#
Related Commands Command
network-clock external
hold-off
network-clock hold-off
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
264
network-clock hold-off {0 | hold-off-value} global
no network-clock hold-off {0 | hold-off-value} global
Disables the hold-off timer.
A warning will be displayed for any value below 300 ms and above 1800 ms.
Modification
This command was introduced.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Description
To override the hold-off timer value for an external interface
Configures a hold-off value on an interface.
OL-23890-01