Ethernet Oam Remote-Loopback (Interface) - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

ethernet oam remote-loopback (interface)

To enable the support of Ethernet operations, maintenance, and administration (OAM) remote loopback
operations on an interface or set a remote loopback timeout period, use the ethernet oam
remote-loopback (interface) command in interface configuration mode. To disable support or remove
the timeout setting, use the no form of this command.
Syntax Description
supported
timeout
seconds
Command Default
Remote loopback is not supported.
Command Modes
Interface configuration (config-if)
Command History Release
12.2(33)SRA
12.4(15)T
12.2(33)SXH
12.2(33)MRA
15.0(1)MR
Usage Guidelines This command enables the support of OAM remote-loopback on an interface. Only after this
functionality is enabled can the local OAM client initiate the OAM remote loopback operation.
Changing this setting causes the local OAM client to exchange configuration information with its remote
peer.
The no form of the command is rejected if the interface is in the loopback mode.
Note
Examples
The following example shows how to enable remote loopback support on interface GigabitEthernet 2/1:
Router(config)# interface gigabitethernet 2/1
Router(config-if)# ethernet oam remote-loopback supported
OL-23890-01
ethernet oam remote-loopback {supported | timeout seconds}
no ethernet oam remote-loopback {supported | timeout}
Supports the remote loopback functionality.
Sets a master loopback timeout setting.
Integer from 1 to 10 that is the number seconds of the timeout period.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.4(15)T.
This command was integrated into Cisco IOS Release 12.2(33)SXH.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
To start Ethernet OAM remote loopback on a switch port, you must first configure the
access-group mode prefer port command in interface configuration mode.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ethernet oam remote-loopback (interface)
163