Set Dscp - Cisco MWR 2941 Command Reference Manual

set dscp

set dscp
To mark a packet by setting the differentiated services code point (DSCP) value in the type of service
(ToS) byte, use the set dscp command in policy-map class configuration mode. To remove a previously
set DSCP value, use the no form of this command.
Syntax Description ip
dscp-value
Command Default
Disabled
Command Modes Policy-map class configuration
Command History Release
12.2(13)T
12.0(28)S
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
414
set [ip] dscp {dscp-value}
no set [ip] dscp {dscp-value}
(Optional) Specifies that the match is for IPv4 packets only. If not used, the
match is on both IPv4 and IPv6 packets.
A number from 0 to 63 that sets the DSCP value. The following reserved
keywords can be specified instead of numeric values:
•
•
•
Modification
This command was introduced. It replaces the set ip dscp command.
Support for this command in IPv6 was added on the in Cisco IOS
Release 12.0(28)S
This command was integrated into Cisco IOS Release 12.4(20)MR. This
release does not support the from-field and table options.
This command was integrated into Cisco IOS Release 12.2(33)MRA. This
release does not support the from-field and table options.
This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support Weighted Random Early Detection (WRED).
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
EF (expedited forwarding)
AF11 (assured forwarding class AF11)
AF12 (assured forwarding class AF12)
OL-23890-01