Table of Contents
Advertisement
link-protection group
link-protection group
To specify the Microwave 1+1 Hot Standby Protocol (HSBY) link-protection group of which the MEP
interface is a member, use the link-protection group command in MEP interface configuration mode.
To remove a link-protection group configuration, use the no form of this command.
Syntax Description
group-number
Command Default
None
Command Modes
MEP Interface configuration (config-if-ecfm-mep)
Command History
Release
15.0(1)MR
Usage Guidelines
You must define the Ethernet CFM domain and service before configuring a link-protection group.
Use this command to configure Microwave 1+1 Hot Standby Protocol (HSBY). For more information
about HSBY, see the
Release
Examples
The following example shows how to configure a link protection group.
Router# configure terminal
Router(config)# ethernet cfm domain LPG level 0
Router(config-ecfm)# id null
Router(config-ecfm)# service number 100 vlan 10 direction down
Router(config-ecfm-srv)# continuity-check
Router(config-ecfm-srv)# continuity-check interval 100ms
Router(config-ecfm-srv)# exit
Router(config-ecfm)# exit
Router(config)# interface gigabitEthernet 0/5
Router(config-if)# ethernet cfm mep domain LPG mpid 1 vlan 10
Router(config-if-ecfm-mep)# link-protection group 12
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
208
link-protection group group-number
no link-protection group group-number
The link-protection group number. Valid values are 1–65535.
Modification
This command was introduced.
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide,
15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Advertisement
Table of Contents
