Clear Ethernet Cfm Ais - Cisco MWR 2941 Command Reference Manual

clear ethernet cfm ais

clear ethernet cfm ais
To clear a maintenance endpoint (MEP) or server maintenance endpoint (SMEP) out of the Alarm
Indication Signal (AIS) defect condition, use the clear ethernet cfm ais command in privileged EXEC
mode.
Ethernet CFM IEEE 802.1ag Standard (CFM IEEE)
Syntax Description
domain
domain-name
mpid
mpid-id
evc
name
vlan
vlan-id
link-status
interface
Ethernet
number
Command Modes Privileged EXEC (#)
Command History Release
12.2(33)SRD
15.0(1)XA
15.0(1)MR
Usage Guidelines
If a MEP does not exit the AIS state when all errors are resolved, use the clear ethernet cfm ais
command with the domain and mpid keywords to clear the AIS defect condition. If a SMEP does not
exit the AIS state when all errors are resolved, use the clear ethernet cfm ais command with the
link-status interface keywords to clear the AIS defect condition.
Examples The following example shows how to clear a SMEP of an AIS defect condition:
Router# clear ethernet cfm ais link-status interface ethernet 0/0
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
48
clear ethernet cfm ais {domain domain-name mpid mpid-id vlan vlan-id |
link-status interface Ethernet number}
Indicates that a maintenance domain is specified.
String of a maximum of 154 characters that identifies the domain.
Indicates that a maintenance point ID (MPID) is specified.
An integer in the range of 1 to 8191 that identifies the MPID.
Indicates that an Ethernet virtual circuit (EVC) is specified.
String identifying the EVC name.
Indicates that a VLAN is specified.
An integer in the range 1 to 4094 that identifies the VLAN.
Indicates either a SMEP or a link up/link down condition.
Indicates that an interface is specified.
Specifies an Ethernet interface.
Integer from 0 to 15 that identifies the Ethernet interface.
Modification
This command was introduced.
This command was modified. The evc keyword and name argument are not
supported in Cisco IOS Release 15.0(1)XA.
This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support Ethernet Connectivity Fault Management (CFM)
Cisco Proprietary Draft 1 (CFM D1).
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01