Service-Policy - Cisco MWR 2941 Command Reference Manual

service-policy

service-policy
To attach a policy map to an input interface, a virtual circuit (VC), an output interface, or a VC that will
be used as the service policy for the interface or VC, use the service-policy command in the appropriate
configuration mode. To remove a service policy from an input or output interface or from an input or
output VC, use the no form of this command.
Syntax Description
input
output
policy-map-name
Command Default No service policy is specified.
A control policy is not applied to a context.
No policy map is attached.
Command Modes ATM bundle-VC configuration (config-atm-bundle)
ATM PVP configuration (config-if-atm-l2trans-pvp)
ATM VC mode (config-if-atm-vc)
Global configuration (config)
Interface configuration (config-if)
Map-class configuration (config-map-class)
PVC-in-range configuration (cfg-if-atm-range-pvc)
PVC range subinterface configuration (config-subif)
Command History Release
12.0(5)T
12.0(5)XE
12.0(7)S
12.0(17)SL
12.1(1)E
12.1(2)T
12.2(14)SX
12.2(15)BX
12.2(17d)SXB
12.2(33)SRA
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
394
service-policy {input | output} policy-map-name
no service-policy {input | output} policy-map-name
Attaches the specified policy map to the input interface or input VC.
Attaches the specified policy map to the output interface or output VC.
The name of a service policy map (created using the policy-map command)
to be attached. The name can be a maximum of 40 alphanumeric characters.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.0(5)XE.
This command was integrated into Cisco IOS Release 12.0(7)S.
This command was implemented on the Cisco 10000 series routers.
This command was integrated into Cisco IOS Release 12.1(1)E.
This command was modified to enable low latency queueing (LLQ) on
Frame Relay VCs.
Support for this command was implemented on Cisco 7600 series routers.
This command was changed to support output policy maps.
This command was implemented on the ESR-PRE2.
This command was implemented on the Supervisor Engine 2 and integrated
into Cisco IOS Release 12.2(17d)SXB.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01