Set Ip Precedence (Policy-Map Configuration) - Cisco MWR 2941 Command Reference Manual

set ip precedence (policy-map configuration)

set ip precedence (policy-map configuration)
To set the precedence value in the IP header, use the set ip precedence command in policy-map
configuration mode. To leave the precedence value at the current setting, use the no form of this
command.
Syntax Description ip-precedence-value
Command Default This command is disabled by default.
Command Modes Policy-map configuration
Command History Release
12.2(14)SX
12.2(17d)SXB
12.2(33)SRA
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Usage Guidelines Table 10
most important.
Table 10
Values
0
1
2
3
4
5
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
424
set ip precedence ip-precedence-value
no set ip precedence
Precedence-bit value in the IP header; valid values are from 0 to 7. See
Table 10
Modification
Support for this command was introduced on the Supervisor Engine 720.
This command was implemented on the Supervisor Engine 2 and integrated
into Cisco IOS Release 12.2(17d)SXB.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
This command was integrated into Cisco IOS Release 12.4(20)MR.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support Weighted Random Early Detection (WRED).
lists the value definitions for precedence values in the IP header. They are listed from least to
Value Definitions for IP Precedence
Definitions
routine
priority
immediate
flash
flash-override
critical
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
for a list of value definitions.
OL-23890-01