Snmp-Server Enable Traps Ethernet Cfm Cc - Cisco MWR 2941 Command Reference Manual

snmp-server enable traps ethernet cfm cc

snmp-server enable traps ethernet cfm cc
To enable Simple Network Management Protocol (SNMP) trap generation for Ethernet connectivity
fault management (CFM) continuity check events, use the snmp-server enable traps ethernet cfm cc
command in global configuration mode. To disable SNMP trap generation for Ethernet CFM continuity
check events, use the no form of this command.
Syntax Description
config
cross-connect
loop
mep-down
mep-up
Command Default When no options are configured, all continuity check traps are enabled.
Command Modes
Global configuration (config)
Command History Release
12.2(33)SRA
12.4(11)T
12.2(33)SXH
12.2(33)SXI2
12.2(33)MRA
15.0(1)MR
Usage Guidelines
The configuration error trap (cEtherCfmCcConfigError) is triggered when a device receives a CCM that
has the same MPID as a locally configured MEP but a different source MAC Address than its own. The
configuration error trap includes the following fields:
•
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
616
snmp-server enable traps ethernet cfm cc [config] [cross-connect] [loop] [mep-down] [mep-up]
no snmp-server enable traps ethernet cfm cc [config] [cross-connect] [loop] [mep-down]
[mep-up]
(Optional) Generates a trap when a CFM misconfiguration exists in the
network.
(Optional) Generates a trap when a cross-connected service exists in the
network.
(Optional) Generates a trap when a forwarding loop exists in the network.
(Optional) Generates a trap when a device has lost connectivity with a
remote MEP or when connectivity from a previously learned remote MEP is
restored after interruption.
(Optional) Generates a trap when a new remote maintenance endpoint
(MEP) has been discovered and learned by the device or when a change
occurs in the port state of a previously discovered remote MEP.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.4(11)T.
This command was integrated into Cisco IOS Release 12.2(33)SXH.
This command was integrated into Cisco IOS Release 12.2(33)SXI2.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Service ID designating the customer service instance to which the event belongs, as configured on
the device reporting the event.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01