Police (Percent) - Cisco MWR 2941 Command Reference Manual

police (percent)

police (percent)
To configure traffic policing on the basis of a percentage of bandwidth available on an interface, use the
police command in policy-map class configuration mode. To remove traffic policing from the
configuration, use the no form of this command.
Syntax Description
cir
percent
percentage
burst-in-msec
bc
conform-burst-in-msec
ms
be
peak-burst-in-msec
pir
percent
conform-action
exceed-action
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
296
police cir percent percentage [burst-in-msec] [bc conform-burst-in-msec ms]
[be peak-burst-in-msec ms] [pir percent percentage] [conform-action action [exceed-action
action [violate-action action]]]
no police cir percent percentage [burst-in-msec] [bc conform-burst-in-msec ms]
[be peak-burst-in-msec ms] [pir percent percentage] [conform-action action [exceed-action
action [violate-action action]]]
Committed information rate. Indicates that the CIR will be used for policing
traffic.
Specifies that a percentage of bandwidth will be used for calculating the
CIR.
Specifies the bandwidth percentage. Valid range is a number from 1 to 100.
(Optional) Burst in milliseconds. Valid range is a number from 1 to 2000.
(Optional) Conform burst (bc) size used by the first token bucket for policing
traffic.
(Optional) Specifies the bc value in milliseconds. Valid range is a number
from 1 to 2000.
(Optional) Indicates that the burst value is specified in milliseconds.
(Optional) Peak burst (be) size used by the second token bucket for policing
traffic.
(Optional) Specifies the be size in milliseconds. Valid range is a number
from 1 to 2000.
(Optional) Peak information rate. Indicates that the PIR will be used for
policing traffic.
(Optional) Specifies that a percentage of bandwidth will be used for
calculating the PIR.
(Optional) Action to take on packets whose rate is less than the conform
burst. You must specify a value for peak-burst-in-msec before you specify
the conform-action.
(Optional) Action to take on packets whose rate is within the conform and
conform plus exceed burst.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01