Show Esmc - Cisco MWR 2941 Command Reference Manual

show esmc

show esmc
To display information about Ethernet Synchronization messaging channel (ESMC) usage, use the show
esmc command in user EXEC or privileged EXEC mode.
Syntax Description detail
interface
interface-name
slot
port
detail
Command Default This command is disabled by default; TCP is the default encapsulation.
Command Modes User EXEC (>)
Privileged EXEC (#)
Command History Release
15.0(1)MR
Examples The following example show how to configuration enables UDP encapsulation on a CESoPSN
pseudowire.
Router# show esmc interface gigabitethernet 0/2
Interface: GigabitEthernet0/0/0
Administrative configurations:
Mode: Synchronous
ESMC TX: Enable
ESMC RX : Enable
QL RX configured : NA
QL TX configured : NA
Operational status:
Port status: UP
QL Receive: QL-SSU-B
ESMC Information rate : 1 packet/second
ESMC Expiry: 5 second
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
488
show esmc {detail | interface interface-name slot / port [detail]
Displays detailed information about the ESMC configuration for all
interfaces.
Specifies an interface.
The name of the synchronous Ethernet interface.
The slot of the synchronous Ethernet interface.
The port number of the synchronous Ethernet interface.
(Optional) Displays additional detail about the ESMC configuration for an
interface.
Modification
This command was introduced.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01