Cisco MWR 2941 Command Reference Manual page 559

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Timers: Uptime/Expires
Interface state: Interface, Next-Hop, State/Mode
(*, 224.0.255.1), uptime 0:57:31, expires 0:02:59, RP is 224.0.0.0, flags: DC
Incoming interface: Null, RPF neighbor 224.0.0.0, Dvmrp
Outgoing interface list:
(192.168.37.100, 224.0.255.1), uptime 20:20:00, expires 0:02:55, flags: C
Incoming interface: Tunnel0, RPF neighbor 10.20.37.33, Dvmrp
Outgoing interface list:
The following is sample output from the show ip mroute command that shows the virtual circuit
descriptor (VCD) value, because an ATM interface with Protocol Independent Multicast (PIM)
multipoint signaling is enabled:
Router# show ip mroute 224.1.1.1
IP Multicast Routing Table
Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected,
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode
(*, 224.1.1.1), 00:03:57/00:02:54, RP 172.16.0.0, flags: SJ
Incoming interface: Null, RPF nbr 224.0.0.0224.0.0.0
Outgoing interface list:
For more information about the show ip mroute command, see the
Reference.
Related Commands Command
clear ip mroute
OL-23890-01
X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,
U - URD, I - Received Source Specific Host Report, Z - Multicast Tunnel,
Y - Joined MDT-data group, y - Sending to MDT-data group
Ethernet0, Forward/Dense, 0:57:31/0:02:52
Tunnel0, Forward/Dense, 0:56:55/0:01:28
Ethernet0, Forward/Dense, 20:20:00/0:02:52
L - Local, P - Pruned, R - RP-bit set, F - Register flag,
T - SPT-bit set, J - Join SPT, M - MSDP created entry,
X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,
U - URD, I - Received Source Specific Host Report, Z - Multicast Tunnel,
Y - Joined MDT-data group, y - Sending to MDT-data group
ATM0/0, VCD 14, Forward/Sparse, 00:03:57/00:02:53
Description
Deletes entries from the mroute table.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show ip mroute
Cisco IOS IP Multicast Command
541