Rep Lsl-Retries - Cisco MWR 2941 Command Reference Manual

rep lsl-retries

rep lsl-retries
To configure the Resilient Ethernet Protocol (REP) link status layer (LSL) number of retries, use the
rep lsl-retries command in interface configuration mode. To restore the default number of retries, use
the no form of this command.
Syntax Description number-of-retries
Command Default The default number of retries is 5.
Command Modes Interface configuration (config-if)
Command History Release
15.0(1)S
15.0(1)MR
Usage Guidelines
REP is a Cisco proprietary protocol that provides functionality to:
•
•
•
The rep lsl-retries command is used to configure the number of retries before the REP link is disabled.
Examples
This example shows how to configure REP link status layer number of retries.
Router# enable
Router# configure terminal
Router(config)# interface gigabitethernet 2/5
Router(config-if)# rep segment 2 edge primary
Router(config-if)# rep lsl-retries 4
Router(config-if)# exit
Related Commands Command
rep lsl-age-timer
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
370
rep lsl-retries number-of-retries
no rep lsl-retries number-of-retries
Specifies the number of LSL retries. The acceptable range is between 3 and
10 retries. The default number of retries is 5.
Modification
This command was introduced on the Cisco 7600 series routers.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Control network loops
Handle link failures
Improve convergence time
Description
Configures the REP link status layer age-out timer value.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01