Ethernet Cfm Cc Enable Level Vlan - Cisco MWR 2941 Command Reference Manual

ethernet cfm cc enable level vlan

ethernet cfm cc enable level vlan
Use the ethernet cfm cc enable level vlan command in global configuration mode to globally enable
transmission of continuity check messages (CCMs). To disable transmission of CCMs, use the no form
of this command.
This command has been replaced with the continuity-check command in Cisco IOS Release 15.0(1)MR.
Note
Syntax Description
any
level-id
,level-id
level-id-level-id
,level-id-level-id
any
vlan-id
,vlan-id
vlan-id-vlan-id
,vlan-id-vlan-id
Command Default
No CCMs are transmitted.
Command Modes
Global configuration (config)
Command History Release
12.2(33)SRA
12.4(11)T
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
112
ethernet cfm cc enable level {any | level-id | ,level-id | level-id-level-id | ,level-id-level-id}
vlan {any | vlan-id | ,vlan-id | vlan-id-vlan-id | ,vlan-id-vlan-id}
no ethernet cfm cc enable level {any | level-id | ,level-id | level-id-level-id | ,level-id-level-id}
vlan {any | vlan-id | ,vlan-id | vlan-id-vlan-id | ,vlan-id-vlan-id}
Enables CCMs for all levels.
Integer from 0 to 7 that identifies a maintenance level.
Integers from 0 to 7, separated by commas, that list levels to be enabled.
Integers from 0 to 7 that define a range of levels to be enabled. The hyphen
is required to separate starting and ending values that define the range.
Integers from 0 to 7 that define a list of ranges to be enabled. The comma
must be entered to separate ranges. The hyphen is required to separate
starting and ending values that are used to define each range of levels to be
enabled.
Indicates all VLANs are to be configured.
Integer from 1 to 4094 that identifies a VLAN to be configured.
Integers from 1 to 4094, separated by commas, that list VLANs to be
configured.
Integers from 1 to 4094 that define a range of VLANs to be configured. The
hyphen is required to separate starting and ending values that are used to
define the range.
Integers from 1 to 4094 that define a list of VLAN ranges to be configured.
The comma must be entered to separate ranges. The hyphen is required to
separate starting and ending values that are used to define each range of
VLANs.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.4(11)T.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01