Connect To The Management Ethernet Port - Cisco Network Convergence System 540 Hardware Installation Manual

Connect to the Management Ethernet Port

RJ-45 Pin
2
3
4
5
6
7
8
Connect to the Management Ethernet Port
You must complete the initial router configuration.
The management Ethernet port provides out-of-band management, which enables you to use the Command
Line Interface (CLI) to manage the router by its IP address. This port uses a 10/100/1000 Ethernet connection
with an RJ-45 interface.
Note
To connect cables to the system management port, attach Category 5 cables directly to the RJ-45 receptacle
on the management Ethernet port.
Cisco Network Convergence System 540 Large Density Routers Hardware Installation Guide
44
To prevent an IP address conflict, do not connect the management Ethernet port until the initial configuration
is complete.
Signal
—
Tx
Ground (GND)
GND
Rx
—
—
Install the Device