Table of Contents
Advertisement
police rate (control-plane)
Table 6
Action
set-discard-class-transmit value
set-dscp-transmit value
set-dscp-tunnel-transmit value
set-frde-transmit value
set-mpls-exp-imposition-transmit
value
set-mpls-exp-transmit value
set-prec-transmit value
set-prec-tunnel-transmit value
set-qos-transmit value
transmit
Examples
The following example shows how to configure the action to take on packets that conform to the police
rate limit:
Router(config)# access-list 140 deny tcp host 10.1.1.1 any eq telnet
Router(config)# access-list 140 deny tcp host 10.1.1.2 any eq telnet
Router(config)# access-list 140 permit tcp any any eq telnet
Router(config)# class-map match-any pps-1
Router(config-cmap)# match access-group 140
Router(config-cmap)# exit
Router(config)# policy-map copp-pps
Router(config-pmap)# class pps-1
Router(config-pmap)# police rate 10000 pps burst 100 packets peak-rate 10100 pps
peak-burst 150 packets conform-action transmit
Router(config-cmap)# exit
Router(config)# control-plane
Router(config-cp)# service-policy input copp-pps
Router(config-cp)# exit
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
314
action Argument Values (continued)
Description
Sets the discard class attribute of a packet and transmits the
packet with the new discard class setting. Valid values are
from 0 to 7.
Sets the IP differentiated services code point (DSCP) value
and transmits the packet with the new IP DSCP value setting.
Valid values are from 0 to 63.
Rewrites the tunnel packet DSCP and transmits the packet
with the new tunnel DSCP value. Valid values are from 0 to
63.
Sets the Frame Relay Discard Eligibility (DE) bit from 0 to 1
on the Frame Relay frame and transmits the packet with the
DE bit set to 1.
Sets the Multiprotocol Label Switching (MPLS)
experimental (EXP) bits in the imposed label headers and
transmits the packet with the new MPLS EXP bit value
setting. Valid values are from 0 to 7.
Sets the MPLS EXP field value in the MPLS label header at
the input interface, output interface, or both. Valid values are
from 0 to 7.
Sets the IP precedence and transmits the packet with the new
IP precedence value. Valid values are from 0 to 7.
Sets the tunnel packet IP precedence and transmits the packet
with the new IP precedence value. Valid values are from 0 to
7.
Sets the QoS group and transmits the packet with the new
QoS group value. Valid values are from 0 to 63.
Transmits the packet. The packet is not altered.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Advertisement
Table of Contents
