Cisco MWR 2941 Command Reference Manual page 672

switchport access vlan
Note The switchport command is not used on platforms that do not support Cisco-routed ports. All physical
ports on such platforms are assumed to be Layer 2-switched interfaces.
This example shows how to cause a port interface that has already been configured as a switched
interface to operate in VLAN 2 instead of the platform's default VLAN in the interface-configuration
mode:
Router(config-if)# switchport access vlan 2
Related Commands Command
show interfaces
switchport
switchport
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
654
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Description
Displays the administrative and operational status of a switching
(nonrouting) port.
Configures a LAN interface as a Layer 2 interface.
OL-23890-01