Table of Contents
Advertisement
Quick Links
Text Part Number:
78-6344-02
Installing Field-Replaceable Units in
Cisco 7100 Series VPN Routers
Product Numbers: ACS-7100-RMK=, MEM-7120/40-64P=, MEM-7120/40-64S=,
MEM-7120/40-128S=, MEM-7120/40-192S=
This document describes installation procedures for field-replaceable units (FRUs) for Cisco 7100
series routers and contains the following sections:
•
Required Tools, page 2
•
Safety Recommendations, page 2
•
Installing the Rack-Mount and Cable-Management Brackets, page 8
•
Removing the Router from the Rack, page 10
•
Removing the Chassis Cover, page 11
•
Replacing SDRAM DIMMs, page 12
•
Replacing the Chassis Cover, page 15
•
Installing and Using PC Cards, page 16
•
Cisco Connection Online, page 19
•
Documentation CD-ROM, page 20
Use this document in conjunction with the Cisco 7100 Series VPN Router Installation and
Configuration Guide publication and the Regulatory Compliance and Safety Information for
Cisco 7100 Series VPN Routers document.
Installation instructions for modular port adapters can be found in the individual document that ships
with the port adapter. For example, if you ordered a PA-4E Ethernet port adapter, the PA-4E Ethernet
10BaseT Port Adapter Installation and Configuration note is shipped with the router.
Installation instructions for the Flash Disk can be found in the Using the Flash Disk document that
shipped with the router.
Warning
equipment. This equipment contains an energy hazard. Disconnect the system before servicing.
Corporate Headquarters
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
Copyright © 1999
Cisco Systems, Inc.
All rights reserved.
Only trained and qualified personnel should be allowed to install, replace, or service this
1
Advertisement
Table of Contents
Related Manuals for Cisco ACS-7100-RMK
Summary of Contents for Cisco ACS-7100-RMK
- Page 1 Cisco Connection Online, page 19 • Documentation CD-ROM, page 20 Use this document in conjunction with the Cisco 7100 Series VPN Router Installation and Configuration Guide publication and the Regulatory Compliance and Safety Information for Cisco 7100 Series VPN Routers document.
-
Page 2: Required Tools
Safety Recommendations For international agency compliance, safety, and statutory information for Cisco 7100 series routers, refer to the Regulatory Compliance and Safety Information for Cisco 7100 Series VPN Routers document that shipped with the router. Any device that uses electricity must be handled carefully; follow these guidelines to ensure general safety: •... -
Page 3: Electrical Equipment Guidelines
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. • Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. • Use caution when installing or modifying telephone lines. Installing Field-Replaceable Units in Cisco 7100 Series VPN Routers... -
Page 4: Electrostatic Discharge Prevention
CEL CAR ALM Chassis Lifting Guidelines A fully configured Cisco 7100 series router weighs approximately 32 pounds (14.5 kg). The chassis is not intended to be moved frequently. Before you install the router, ensure that your site is properly prepared so you can avoid having to move the chassis later to accommodate power sources and network connections. -
Page 5: Site Requirement Guidelines
As an alternative, you can mount the router on an equipment shelf provided that the rack dimensions allow you to secure the router to the shelf, and the overall configuration permits safe installation and access. However, we recommend rack-mounting the router. Figure 2 shows the Cisco 7100 series router footprint and outer dimensions. - Page 6 (installing or moving a port adapter or connecting cables). Otherwise, allow 19 inches (48.3 cm) of clearance to remove a port adapter. 6 Installing Field-Replaceable Units in Cisco 7100 Series VPN Routers...
-
Page 7: Power Connection Guidelines
The chassis ground requires M3.5 screws, which are included. (For instructions on how to properly ground the chassis, refer to Chapter 3, “Installing Cisco 7100 Series Routers” in the Cisco 7100 Series VPN Router Installation and Configuration Guide. -
Page 8: Attaching The Cable-Management Bracket
100 to 240 VAC and 50/60 Hz. We recommend an uninterruptible power source to protect against power failures at your Note site. We recommend powering a Cisco 7100 series router from a 15A receptacle at the power source. Installing the Rack-Mount and Cable-Management Brackets... -
Page 9: Attaching The Rack-Mount Brackets
After the brackets are secured to the chassis, you can rack-mount the router. Using the Step 3 screws that you provide, attach the chassis to the rack as shown in Figure 6. Installing Field-Replaceable Units in Cisco 7100 Series VPN Routers... -
Page 10: Removing The Router From The Rack
The brackets can also be installed with the front panel forward. To complete the next three installation steps, refer to Chapter 3, “Installing Note Cisco 7100 Series Routers” in the Cisco 7100 Series VPN Router Installation and Configuration Guide. Step 4 Attach the grounding lug to the chassis. -
Page 11: Removing The Chassis Cover
C i s 7 1 0 R I E Lift the chassis cover upward and pull it away from the tabs on the rear of the chassis. Step 5 (See Figure 8.) Installing Field-Replaceable Units in Cisco 7100 Series VPN Routers... -
Page 12: Replacing Sdram Dimms
SDRAM DIMMs for the following reasons: • You have upgraded to a new Cisco IOS feature set or release that requires more memory. • You are using very large routing tables or many protocols (for example, when the router is set up as a connection device between large external networks and your internal network). - Page 13 Pull the socket tabs away from the DIMM to eject the DIMM, and then pull the DIMM Step 5 out of the socket. The socket tabs hold the DIMM tightly, so be careful not to break the tabs. (See Figure 10.) Installing Field-Replaceable Units in Cisco 7100 Series VPN Routers...
- Page 14 If no error messages are displayed: Power off the router and disconnect site power. Reinstall the router in the rack. (See the “Installing the Rack-Mount and Cable-Management Brackets” section on page 8.) 14 Installing Field-Replaceable Units in Cisco 7100 Series VPN Routers...
-
Page 15: Replacing The Chassis Cover
Cable-Management Brackets” section on page 8.) Reinstall all interface cables. Step 6 Figure 11 Replacing the Chassis Cover Chassis tabs Chassis cover C i s 7 1 0 Chassis bottom Front panel R I E Installing Field-Replaceable Units in Cisco 7100 Series VPN Routers... -
Page 16: Installing And Using Pc Cards
The installation procedure is generic and can be used for any PC Card (Flash Disk or Flash memory card) in either PC Card slot position (slot 0 or slot 1) for any Cisco 7100 series router model. You do not need to power off the system to insert or eject a PC Card. - Page 17 Installing and Using PC Cards Figure 13 Removing the PC Card Slot Cover in a Cisco 7100 Series Router PC Card slot cover AC OK DC OK SLOT 0 SLOT 1 FE 0 / 0 0 / 1 AC OK...
- Page 18 PC Card slot. (See Figure 15, part c.) Remove the PC Card from the slot and place it in an antistatic bag. Step 6 18 Installing Field-Replaceable Units in Cisco 7100 Series VPN Routers...
-
Page 19: Cisco Connection Online
For a copy of CCO’s Frequently Asked Questions (FAQ), contact cco-help@cisco.com. For additional information, contact cco-team@cisco.com. If you are a network administrator and need personal technical assistance with a Cisco Note product that is under warranty or covered by a maintenance contract, contact Cisco’s Technical Assistance Center (TAC) at 800 553-2447, 408 526-7209, or tac@cisco.com. -
Page 20: Documentation Cd-Rom
LightStream, LightSwitch, MICA, NetRanger, Registrar, StrataView Plus, Stratm, TeleRouter, and VCO are registered trademarks of Cisco Systems, Inc. in the U.S. and certain other countries. All other trademarks mentioned in this document are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any of its resellers.