Chapter 3: Getting To Know The Wireless-G Ethernet Bridge; The Back Panel; Figure 3-1: Back Panel - Cisco Linksys WET54G-EU v3 User Manual

Wireless-G Ethernet Bridge

Chapter 3: Getting to Know the Wireless-G Ethernet Bridge

The Back Panel

All connections to the Bridge are made through the ports on its back panel, shown in Figure 3-1.
Reset When pressed, the Reset button resets the Bridge to its factory default settings.
Important: If you reset the Wireless-G Ethernet Bridge, you will
erase all of your settings (WEP encryption, wireless settings,
etc.) and replace them with the factory defaults. Do not reset the
Wireless-G Ethernet Bridge if you want to retain these settings.
LAN The LAN port is where you will connect the Ethernet network cable.
Power The Power port is where you will connect the power adapter.
NOTE: If you use a Power over Ethernet (PoE) device to supply
data and power through the Ethernet network cable, then you
do not need to use the Power port.
Chapter 3: Getting to Know the Wireless-G Ethernet Bridge
The Back Panel
All manuals and user guides at all-guides.com

Figure 3-1: Back Panel

6