Cisco MWR 2941 Command Reference Manual page 344

protocol (ATM)
inarp
[no] broadcast
disable-check-subnet
enable-check-subnet
Inverse ARP is enabled for IP if the protocol is running on the interface and no static map is configured.
Subnet checking for InARP is disabled by default.
Command Modes
Interface-ATM-VC configuration (for an ATM PVC or SVC)
PVC-in-range configuration (for an individual PVC within a PVC range)
PVC range configuration (for an ATM PVC range)
VC-class configuration (for a VC class)
Command History Release
11.3
12.1
12.1(5)T
12.2(13)T
12.2(33)SRA
12.2SX
12.2SRE
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Usage Guidelines Command Application
Use this command to perform either of the following tasks:
•
•
•
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
326
Enables Inverse ARP on an ATM PVC. If you specify a protocol address
instead of inarp, Inverse ARP is automatically disabled for that protocol.
(Optional) Indicates that this map entry is used when the corresponding
protocol sends broadcast packets to the interface. Pseudobroadcasting is
supported. The broadcast keyword of the protocol command takes
precedence if you previously configured the broadcast command on the
ATM PVC or SVC.
(Optional) Disables subnet checking for InARP.
(Optional) Enables subnet checking for InARP.
Modification
This command was introduced.
The ppp and virtual-template keywords were added.
The ip and ipx options were made available in PVC range and PVC-in-range
configuration modes.
The apollo, vines, and xns keywords were removed because Apollo Domain,
Banyan VINES, and Xerox Network Systems are no longer supported in the
Cisco IOS software.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
This command is supported in the Cisco IOS Release 12.2SX train. Support
in a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
The disable-check-subnet and enable-check-subnet keywords were added.
This command was integrated into Cisco IOS Release 12.4(20)MR.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Configure a static map for an ATM PVC, SVC, or VC class.
Enable Inverse ARP or Inverse ARP broadcasts on an ATM PVC or PVC range by configuring
Inverse ARP directly on the PVC, in the PVC range, or in a VC class (applies to IP protocol only).
Enable the router to respond to an InARP request when the source IP address contained in the
request is not in the subnet as the receiving sub-interface on which PVC is configured.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01