Cisco MWR 2941 Command Reference Manual page 320

police (policy map)
burst
ms
flow
mask
dest-only
full-flow
src-only
Command Default No policing is performed.
Command Modes Policy-map class configuration (config-pmap-c)
Command History Release
12.2(14)SX
12.2(17d)SXB
12.2(17d)SXB3
12.2(18)SXD
12.2(18)SXE
12.2(18)SXF
12.2(33)SRA
12.2(31)SB
12.2(33)SB
12.2(33)SXH2
12.2(33)SXI
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
302
(Optional) The token-bucket size in milliseconds (ms) for handling a
burst. Valid range is from 1 to 2000.
Milliseconds. When bandwidth is specified as a percentage, this keyword
must follow the burst argument.
Specifies a microflow policer that will police each flow.
Specifies the flow mask to be used for policing.
Specifies the destination-only flow mask.
Specifies the full-flow mask.
Specifies the source-only flow mask.
Modification
This command was introduced on the Supervisor Engine 720.
This command was implemented on the Supervisor Engine 2 and integrated into
Cisco IOS Release 12.2(17d)SXB.
The police bps minimum rate was lowered from 32,000 to 8,000 on FlexWAN
interfaces only.
This command was changed as follows:
Added set-mpls-exp-topmost-transmit to the valid values for the
•
conform-action keyword.
Changed the set-mpls-exp-transmit keyword to
•
set-mpls-exp-imposition-transmit.
The bps maximum rate was increased from 4,000,000,000 to 10,000,000,000 bps
to support 10-Gigabit Ethernet.
The CIR maximum rate was increased to 10,000,000,000 bps.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
The command behavior was changed so that if you modify only the police rate
parameters and not the police actions, the police actions default to the default
actions: conform-action transmit, exceed-action drop, and violate-action drop.
This was implemented on the Cisco 10000 series router for the PRE3.
The command behavior was changed so that if you modify only the police rate
parameters and not the police actions, the police actions are preserved. This was
implemented on the Cisco 10000 series router for the PRE3 and PRE4. For more
information, see the "Usage Guidelines" section.
The CIR maximum rate was increased to 64,000,000,000 bps.
The minimum CIR token bucket size was reduced to 1 byte.
This command was integrated into Cisco IOS Release 12.4(20)MR.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01