Show Controllers Fabricq Errors - Cisco XR 12000 Command Reference Manual

Fabric Management Commands

show controllers fabricq errors

To display the count of hardware errors associated with the fabric queue driver, use the show controllers
fabricq errorscommand in administration EXEC mode.
show controllers fabricq errors [location node-id]
Syntax Description
location node-id
Command Default
Information about errors for all route processors (RPs) on the router is displayed
Command Modes
Administration EXEC
Command History
Release
Release 3.2
Usage Guidelines
Use the show controllers fabricq errors command to display statistics about hardware errors. Specifying
a location displays information only if that location is a RP.
The show controllers fabricq errorscommand is intended for use while performing debugging procedures.
Task ID
Task ID
root-system
Examples
The following is sample output from the show controllers fabricq errorscommand for location 0/1/CPU0:
RP/0/0/CPU0:router# admin
RP/0/0/CPU0:router(admin)# show controllers fabricq errors location 0/1/CPU0
Location 0/1/0:
ToFab Errors:
Error Type
-----------------------------------------------------------
SRAM Parity
DMA Address
DMA Size
Fusilli Parity
PCI TRANS64
OL-28456-02
(Optional) Displays statistical information for the designated node. The node-id
argument is entered in the rack/slot/module notation.
Error Count Max Rate Rate Exceeded Count
0 2
0 100
0 100
0 2
0 2
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
Modification
This command was introduced.
Operations
read, write
0
0
0
0
0
show controllers fabricq errors
103