Ping Ethernet - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

ping ethernet

To send Ethernet connectivity fault management (CFM) loopback messages to a destination
maintenance endpoint (MEP), use the ping ethernet command in privileged EXEC mode.
Syntax Description
mac-address
mpid
mpid
multicast
domain
domain-name
port
vlan
vlan-id
cos
cos-value
source
source-mpid
de
Command Default
A CFM ping operation to the specified MEP is performed.
Command Modes
Privileged EXEC (#)
Command History Release
12.2(33)SXI2
12.2(33)SRE
12.2(33)MRA
15.0(1)MR
OL-23890-01
ping ethernet {mac-address | mpid mpid | multicast} {domain domain-name {port | vlan
vlan-id}} [cos cos-value | source source-mpid [cos cos-value]] [de]
MAC address of the destination MEP in the format abcd.abcd.abcd.
Specifies a maintenance point identifier.
Integer from 1 to 8191 that identifies the MEP.
Specifies a multicast loopback message.
Specifies the domain where the destination MEP resides.
String of a maximum of 154 characters that identifies the domain.
Specifies a port MEP.
Specifies a VLAN.
Integer from 1 to 4094 that identifies the VLAN.
(Optional) Specifies a class of service (CoS) for a MEP that will be sent in
Ethernet CFM messages.
(Optional) Integer from 0 to 7 that identifies the CoS.
•
(Optional) Specifies a MEP's class of service (CoS) that will be sent in
Ethernet CFM messages.
(Optional) Integer from 1 to 8191 that identifies the source MEP.
(Optional) Specifies if the packet is drop eligible. The default is "false."
•
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)SRE.
This command was integrated into Cisco IOS Release 12.2(33)MRA. The
cos parameter was not supported in this release.
This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support the level keyword used to configure CFM Draft 1.0.
The default is retrieved from the MEP identified by the maintenance
endpoint ID (MPID) if the cos option is not configured. If the mpid
option is not configured, the default is the highest priority on the egress
interface.
The de option is platform dependent.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ping ethernet
291