Ethernet Cfm Mep Crosscheck - Cisco MWR 2941 Command Reference Manual

ethernet cfm mep crosscheck

ethernet cfm mep crosscheck
To enable cross-checking between the list of configured remote maintenance endpoints (MEPs) of a
domain and MEPs learned through continuity check messages (CCMs), use the ethernet cfm mep
crosscheck command in privileged EXEC mode. To disable cross-checking, use the ethernet cfm mep
crosscheck disable command.
CFM IEEE 802.1ag Standard (CFM IEEE)
Syntax Description
enable
disable
vlan
vlan-id
any
vlan-id-vlan-id
,vlan-id-vlan-id
domain
domain-name
port
Command Modes
Privileged EXEC (#)
Command History Release
12.2(33)SRA
12.4(11)T
12.2(33)SXH
12.2(33)SRD
12.2(33)SXI2
12.2(33)MRA
15.0(1)MR
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
124
ethernet cfm mep crosscheck {enable | disable} domain domain-name {port | vlan{vlan-id |
vlan-id-vlan-id | ,vlan-id-vlan-id}}
Indicates that cross-checking will occur.
Indicates that cross-checking will not occur.
Indicates a VLAN for cross-checking.
Integer from 1 to 4094 that identifies the VLAN.
Indicates all VLANs are to be configured.
•
Integer values from 1 to 4094. The hyphen is required to separate starting
and ending VLAN ID values that are used to define a range of IDs.
(Optional) Integer values from 1 to 4094. The comma must be entered to
separate VLAN ID ranges. The hyphen is required to separate starting and
ending VLAN ID values that are used to define each range of IDs.
Specifies a maintenance domain.
String of a maximum of 154 characters that identifies the
maintenance domain.
Specifies a DOWN service direction with no VLAN associations (untagged).
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.4(11)T.
This command was integrated into Cisco IOS Release 12.2(33)SXH.
The evc keyword and evc-name argument were added on the Cisco 7600
Series Route Switch Processor 720 (RSP 720) and the Cisco 7600 Series
Supervisor Engine 720.
This command was integrated into Cisco IOS Release 12.2(33)SXI2.
This command was integrated into Cisco IOS Release 12.2(33)MRA. This
release does not support the evc parameter.
This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support the level keyword used to configure CFM Draft 1.0.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
This option is supported only in CFM D1.
OL-23890-01