Ethernet Oam Link-Monitor Frame-Seconds - Cisco MWR 2941 Command Reference Manual

ethernet oam link-monitor frame-seconds

ethernet oam link-monitor frame-seconds
To configure a frame-seconds period on an Ethernet operations, maintenance, and administration
(OAM) interface, use the ethernet oam link-monitor frame-seconds command in configuration
template and interface configuration mode. To remove the threshold or window, use the no form of this
command.
Syntax Description
threshold
high
none
high-frames
low
low-frames
window
milliseconds
Command Default
The ethernet oam link-monitor frame-seconds command is not configured.
Command Modes Configuration template (config-template)
Interface configuration (config-if)
Command History Release
12.2(33)SRA
12.4(15)T
12.2(33)SXH
12.2(33)MRA
15.0(1)MR
Usage Guidelines
The ethernet oam link-monitor frame-seconds command configures a number of error frames that
triggers an action or a period of time in which error frames are counted.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
148
ethernet oam link-monitor frame-seconds {threshold {high {none | high-frames} | low
low-frames} | window milliseconds}
no ethernet oam link-monitor frame-seconds {threshold {high | low} | window}
Sets a number at, above, or below which an action is triggered.
Sets a high error frame-seconds threshold in number of seconds.
Disables a high threshold.
Integer in the range of 1 to 900 that is the high threshold in number of frames.
There is no default. The high threshold must be configured.
Sets a low error frame-seconds threshold in number of seconds.
Integer in the range of 1 to 900 that sets the low threshold in number of
frames. The default is 1.
Sets a polling window during which error frames are counted.
Integer in the range of 100 to 9000 that represents a number of milliseconds
in a multiple of 100. The default is 1000.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.4(15)T.
This command was integrated into Cisco IOS Release 12.2(33)SXH.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01